White film

Winemaking Talk - Winemaking Forum

Help Support Winemaking Talk - Winemaking Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

grapecrusher

Member
Joined
Apr 9, 2013
Messages
32
Reaction score
5
There is a white film on top of one of my carboys. What is it How do I get rid of it and is my wine ruined?
 
Grape crusher,

It sounds like you've got mycoderma floating on the surface, a few questions before trying to diagnose it:

  • Does the wine have any off odors?
  • How long has it been aging?
  • When is the last time that you tested for PH, TA, and SO2, without these numbers, it will be a guesstimate on how to correct it.

This is caused by a few different scenarios, one being too much head space in the carboy, another possible reason is that your sulfite level is probably real low, not adequate to protect your wine.

The good news, this is easily fixed, in most cases, unless it has been sitting like that for a while and it has a strong "rotten egg" smell, worse if it has off flavors.

I've seen this on a few batches that I had aging, I hadn't topped off enough (now I top off about 1 inch from the bung), and I hadn't tested my wine in a while.

When I tested them I found that my SO2 levels were just about depleted; I removed the film by slowly filling the carboy with distilled water (we're talking about less than a half cup) until the film was at the very top of the carboy neck about to spill over, I removed it, removed enough wine to be able to accommodate the meta that I needed to add to bring the levels back up, and actually slightly elevated to kill off any residual bacteria, I put a clean sanitized bung and airlock back in and the wine was fine.

If the wine has an off odor, the same procedure will be necessary, but you may need to splash rack, or if it persists, an addition of Redulees might be necessary.

The info that is needed to diagnose properly is:

Test results (PH, TA, and SO2) and if there is any off odors or flavors.

I hope that this helps.

Tom
 
Thx tom. I suspect I have too much air space in carboy as far as testing I'm not as advanced as you . I don't know how or what to test
 
An alternate method is to place a you racking tube below the surface of wine and rack into a new carboy. splash racking is not required. leave at least one inch of old wine behind. done carefully you are removing the wine below the white film. Assuming you have 5 gallons add at least 1/4 teaspoon K-meta to the wine. I would add this same amount to the other wines you have also.
 
grapecrusher, you can buy a few simple test kits that can test the Acidity, PH and SO2 levels.
Sal, the reference to splash racking was in reference to any off, rotten egg odors.
 

Latest posts

Back
Top