Black Forrest Port Question

[ShelleyDickison]

Let's pretend I had an Old Timers moment.....I was looking at my BFP in primary and noticed on the front I hade marked down
SG 1.21, sounded a bit high so I check the instruction sheet and it was 1.021, ok that sounded a bit low, looked at my scrap paper and it says 1.12...... Of these three which would seem most likely. Maybe mor coffee before I start another kit in the morning.

 

[cpfan]

I haven't made this kit, but 1.112 or 1.120 sounds most reasonable to me. 1.210 is too high, 1.021/1.012 is too low for a starting sg.

BTW, sg should always be specified as 3 decimal places. It might have helped to prevent this confusion.

Steve

 

[FTC Wines]

Shelly, my BFP was SG 1.116 at the start a few months ago. Roy