Chardonnay issues

Winemaking Talk - Winemaking Forum

Help Support Winemaking Talk - Winemaking Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

nicklausjames

Senior Member
Joined
Mar 25, 2014
Messages
223
Reaction score
11
I have a chardonnay that is bulk aging in a 13.2 gal demijohn. I measured the ph and it was 4.2 so I added 32 g tartaric and it dropped to 4.13. I tasted and it tastes fine. I also did some bench trials and brought it to 3.8. It tasted pretty acidic.
My question is about leaving it at 4.13. I plan on barrel aging it for 3 months. I know the high ph increases the chances of spoilage, so my question is whether anyone has any recommendation on what I should do.
 
What is the TA - the PH is a bit high. 3.5-3.7 range for chardonnay should be what you are looking for.
 
That is a bit low, but is certainly in the ballpark. You can leave it at that level, but I would adjust the level of SO2 to the level correct for that PH to avoid spoilage.

For the PH you currently have, you probably want a SO2 target somewhere around 70ppm (Minimum).
 
Last edited:
Sounds like these were perhaps harvested late? What was the brix? You are at the lower level of TA and could go up towards 0.8 but if its tasting tart already then maybe not. Are you checking TA by pH meter? You may just have to call it quits if you think its tart at 3.8. Like JohnT said sulfite to that pH level and stick a fork in it.
 
I was also wondering if he used juice buckets or fresh grapes.
 
No I used juice buckets. I don't know the brix bc they were already fermenting when I got them. I think it was 10-15 brix when I got it.
 
Cold stabilize @ 30 degrees for three or four weeks. Check acid levels and ph. Add acid back if needed.
 

Latest posts

Back
Top