Bad spigot experience...

Winemaking Talk - Winemaking Forum

Help Support Winemaking Talk - Winemaking Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Cool thank you for the follow up… I imagine that since you placed it from the inside with the large end of the taper, more pressure on the inside would tend to ensure a better seal. Interesting idea with the SS finishing nail. I was looking for a threaded plug and will post my findings if/when I hear back from a few suppliers.
Dave, I just thought of another alternative that I could try very easily. In the past, I have used this type of plug on two 3 gallon plastic carboys that I bought used and which already had holes drilled. This is inserted into the hole and the wing nut is run in, pulling the screw head and washer (on the inside), expanding the diameter of the plug. It seems to work well but I have not used the 3 gallon carboys because I am concerned about the metal screw and the black rubber. They both may be okay, but I have not pursued that.

1708226742105.png
However, I do have more #5 stoppers that I could alter and use similarly. I would need to drill a hole through the stopper from top to bottom. I would put a stainless steel screw and washer against the large diameter of the stopper, feed the stopper through the 1" hole from the inside of the carboy and attach a washer and wing nut on the outside against the small diameter of the stopper. Tightening the wing nut would increase both inside and outside diameters, sealing the hole. I think I am going to give this a try because I like the mechanical attachment.

I am sure there are a number of people reading this thread and thinking, "Why doesn't he just deep six the old carboys with holes and get new one?!" Where is the fun in that?
 
So I did fill those bad spigots with silicone but am really hesitant to use them. I have a couple of spigots that were designed for bucket fermentors that would work but no retaining nut to go with them. After wandering through the local hardware store, it appears a 3/4 pvc electrical female coupling will do the trick. I’ll see what responses I get from those companies after the holiday weekend and post them. For $1.89 I think this is a bargain in the short term.

I do like the stopper and SS screw/washer idea, I’m just not sure the plastic is thick enough to support it. Unless you score the stopper so the plastic fits inside a channel of sorts?

And I’m with you… there HAS to be a solution I can come up with to fix this. It usually costs more time and money, but it’s also more fun.
 
Bucket spigots it is for this round. I wonder if there’s a way (I’m sure there is but a way that I’m able to do) to melt a plastic disk to the surrounding plastic like how pvc cement works. I haven’t found a good alternative out there for a water tight hole plug in that size.

IMG_3390.jpegIMG_3389.jpeg
 
Back
Top