Christmas wine recipe

Winemaking Talk - Winemaking Forum

Help Support Winemaking Talk - Winemaking Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I reached my cranberry clementine wine again. The pH was 2.88. That did not seem to inhibit the yeast (K1-V116), but it is a little too acidic for drinking. I added 1/8 tsp. of Potassium Bicarbonate to 1 gallon to raise the pH a little bit. The next time I rack I will measure it again. I want to adjust the pH a little bit at a time.
 
So I’m curious about nutrient addition in non-grape fruit wine.

In mead, @dmw_chef suggests 1/2 G per gallon of Fermaid K and O at 24, 48, 72 hours and then at 1/3 break for a total of 2 G per gallon.

In grape wine making it appears (generally) to be something like DAP full dose at signs of fermentation. Then when 1/3 of the way through a half dose of Fermaid K and the same at 2/3 the way through (total of 1.5 G/gallon). If needed, Fermaid O below 1.030.

Is making other fruit wine closer to making grape wine? I feel an “it depends” coming...
 
I've been making fruit wine for 49 years and have always added all the dry ingredients together with the fruit and water, except for the yeast. Maybe twice the Cranberry wines have needed a second pack of yeast. I've never added Fermaid X,Y or Z, just the generic nutrient. Most recipes that I've read add it all at once.
 
I’ve just done about two hours of research on YAN variations and nutrient needs among fruits and the answer is definitely “it depends”. YAN varies widely by cultivar, year, climate, harvest date, and viticultural practices (like adding nitrogen to the soil or not), and nutrient addition to a must of any kind depends on both YAN and individual yeast needs.

Cornell extension has some good information, as does University of Vermont. The Australian Wine Institute has some particular levels for grapes and a DAP calculator. Penn State has some great information in addition to a good explanation of why it’s bad to add DAP at the beginning of fermentation. Of course, WineMaker has a great explanation as well.

So... part science, part experience, part style. I haven’t found anything yet that gives a general range of where fruits land on the YAN scale, except for this article by the NYS AG Experimental Station in Geneva. It seems like GoFerm is helpful at the beginning and end of fermentation as are Fermaid products 1/3 and 2/3 through fermentations.

I don’t have access to YAN instruments, hence my original question in trying to determine what to add when, but it does sound like “it depends”. Too little nutrient will stress the yeast and cause delays or a stuck fermentation and H2S. Too much can cause a huge proliferation of yeast and then a stress when they run out of food and also excess food for other organisms if not enough sulfite is used at the end of fermentation.

There’s a lot of discussion about adding it all up front versus over the course of the fermentation. I believe these may be style or pragmatic points, at the moment. I’m still interested in what everyone does and how “other than grape” fruit wines fare in this arena.
 
@David Violante thanks for sharing your research. For my fruit wines I usually add DAP at the same time as I add the yeast. I am getting ready to start my first batch of mead, so I am reading up on TOSNA and have purchased some Fermaid O. I don't know if using Fermaid O or TOSNA for fruit wine would make any difference in the final flavor. It would be an interesting experiment to make two otherwise identical batches to compare the effects of different approaches to nutrients.

It sounds like the ideal situation is for the yeast to run out of nutrients at the same time that it finished metabolizing all the sugar. I'm not sure how we can do that at home without the ability to measure YAN. I'm sure that different types of fruit and different amounts of fruit per gallon would require different amounts of nutrient.
 
Advanced Nutrients in Meadmaking is a great accessible primer on YAN and nutrition that is likely also very applicable to grape and fruit winemaking in terms of the broad concepts. (It even cites some members here!)

In mead, @dmw_chef suggests 1/2 G per gallon of Fermaid K and O at 24, 48, 72 hours and then at 1/3 break for a total of 2 G per gallon.

Note: That's going to be dependent on yeast, OG, and YAN contributions from fruit. That schedule is for that OG, yeasts in QA23's YAN bracket, and the assumption that your must has <40 YAN as is. If you want a schedule that will push EC-1118 to 21-22% it's gonna be different.

It sounds like the ideal situation is for the yeast to run out of nutrients at the same time that it finished metabolizing all the sugar.

I believe almost all YAN is ideally consumed by the time the yeast has finished the growth phase.
 
For my fruit wines I usually add DAP at the same time as I add the yeast.

Not a good idea. DAP at pitch can stress the yeast and create of flavors. I usually see it recommended to add DAP at 24h after pitch.

I am getting ready to start my first batch of mead, so I am reading up on TOSNA and have purchased some Fermaid O.

TOSNA is a fine schedule that works well up to about 14%. After that, some of the assumptions it makes start to break down a bit; basically the hypothesis that I and some of my friends share is that it over estimates the effectiveness of Fermaid O, which is propped up by not including the YAN contribution of Go-Ferm in its calculations, a crutch that breaks down as you push to higher ABVs.
 
I pitch yeast the next day, but always add everything else all at once. What I'm finding out about this wine gig is just like the brewing gig, most of what is taught and is considered gospel is just someone trying to make a very easy process, super difficult.
ie - degassing, degassing for 10 to 30 minutes, adding nutrients on a hourly schedule, reracking 4 times, aging 1 year minimum, creating a yeast slurry. You get my point. These all do work great, but not needed in most cases.
 
Follow up~ tasted it just the other day to see how it was progressing and it tastes more like a grapefruit wine. Will the cranberry come through at some point? It’s nice and clear, very tart. I’ll have to back sweeten a little.
 
It is an old thread but I wander how this Cranberry Clementine wine tastes now if you still tried after all those months. I would like to start this recipe in the next few days. I know you (Raptor99) noticed too much acidity at the beginning. I made a plain fresh Cranberry wine several months ago and it is still very acidic. I'm not sure how to deal with cranberry acidity. Maybe a small addition of another fruit would help?
 
We tried my cranberry clementine wine last year for thanksgiving. It was a huge hit with the family. I have a few bottles left, and I haven't tasted it for 6 months, so I need to give it a try again.

I started a new batch in Feb. this year, from fresh cranberries that I froze last Nov. This time I used orange zest instead of clementine peels. I think that that worked well. To adjust the acidity, I added a small amount of Potassium Bicarbonate, a little at a time, until the pH was up to about 3.2. When adjusting the acid, it is best to add a small amount of Potassium Bicarbonate, stir, and then wait 24 hours before re-checking the pH. Then you can add a little more if necessary.

Cranberry wine definitely needs to be backsweetened to be good. Even a very acidic wine can be good if you add a little more sugar. It sounds like your cranberry wine has finished fermenting, so I suggest you bench test some sugar additions. Take a small sample and add measured amounts of sugar until you like the flavor, Then you can calculate the amount of sugar needed for the entire batch.
 
Thanks for the reply. I will definitely try this. My Cranberry wine is already bottled and everyone likes it but for me it's a little too acidic. Potassium Bicarbonate and ph meter is on my list.
 
Since it is already bottled, I suggest that you sweeten it a little in the glass. That might be all that you need. The advantage of that approach is that each person can sweeten it according to their own taste. It only takes a small amount of sugar to make a difference.

Coke is very acidic, probably more acidic than your cranberry wine. But we don't notice the acidity because of the sweetness.
 
Christmas Pudding wine
I found this recipe on the net. I haven't tried it, so I don't know what it's like.
Ingredients:
  • 2lb of Christmas puddings
  • 2 over ripe bananas
  • 2kg granulated sugar
  • 500g dark brown sugar
  • 500g sultanas or raisins
  • 1 tin of grapefruit segments
  • High alcohol / desert wine yeast
Method:
Slice and dice the Christmas pudding and add to a pan of boiling water, and add your sugar - both the granulated and the brown. Add the bananas (skins as well), the sultanas or raisins and the tine of grapefruit segments and simmer your concoction for about an hour.

Once your kitchen has filled with a Christmas aroma that will make you sing jingle bells, our the must into your sterilised fermentation bucket, top up with water to just over 2 gallons, and allow to cool before pitching in the yeast.

BigDave K might like to have a look at this site, he has loads of recipes and videos.
http://www.happyhomestead.co.uk/christmas-pudding-wine.html


After 7 days of your wine fermenting in the primary vessel, strain off the juice into a demijohn and let it ferment further. By adding a teaspoon of sugar every couple of days and feeding the yeast, the wine will make the most of the high alcohol wine yeast that you have used, resulting in a wine that has more bang than the combined Christmas crackers on your festive table.

Keep on top of the racking process, the suet used in the Christmas pudding does continue to drop for quite some time and can cause off flavours if left. Allow to mature and bottle.

Sit back, relax and have a fantastic Christmas!
 
Last edited:

Latest posts

Back
Top