Simple bottle labeler/applicator

Winemaking Talk - Winemaking Forum

Help Support Winemaking Talk - Winemaking Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

bein_bein

Senior Member
Joined
Jan 4, 2008
Messages
224
Reaction score
149
Simple bottle labeler/applicator plans

Had a request for plans for the label applicator I made...so here goes...
materials;
1/4 Luan/plywood 15"x 30" min
two bracket rollers (harbor freight example)
adhesive backed shelf/drawer liner
wood glue
finish nailer (or hammer)
drill motor / 5/16 drill

I glued all joints and used a finish/brad nailer to build mine. I guess you could use a hammer, but I tend to break stuff when I start swingin' a hammer.. :D soo..

Here's pics with the dimensions of my applicator....feel free to change/improve yours as desired/needed:


pv1.jpg


sv1.jpg


The 2" dimension can be adjusted bigger so the corner braces (see below) do not have to be thinned at one end.
Just make sure that you alter the 5.5 dimension as well...

bv1.jpg


aux1.jpg


This is pretty basic stuff... make sure that you align and clamp both end pieces together and drill the roller holes at the same time, so that your rollers will be parallel. Also make sure you use a square to keep the whole unit nice and straight as you put it together. I built the 4 sides, mounted the centermost roller, then put the large top piece on, and aligned as close to the roller as possible, making sure the 'box' was square as I did so, . (If memory serves correct, I left this top piece a little long, test fitted, marked for length, then cut and installed) Lastly, I glued and nailed the corner braces...have fun with it ! :D

oh yeah... here's a video of it in action ..

 
Last edited:
Thanks for sharing your Idea. Guess what I will be building?

RR
 
Nice how about a video showing how it works?

Click on the bottom pic (the one under the sentence "oh yeah... here's a video of it in action .." )
:slp lol ..should take you to a video demonstration.

Please post the cost for supplies

Since I built mine 2 yrs ago out of mostly scrap or stuff lying around, I have no idea on costs.. :d The rollers will probably be your biggest investment ....unless you want to use this as an excuse to go out and buy that pneumatic finish nailer and compressor you've always wanted....:db lol
 
Last edited:
I've heard that old typewriter rollers work well if you can find them anymore.

What kind of labels are you using in your video demonstration? Are they standard Avery labels?
 
Yup Avery. That one was Avery 6878, I have also used Avery 5264 and 22809
 
You did a great job on that labeler. The amount of labeling I do wouldn't warrant making one but if one fell onto my lap I would use it.
 

Latest posts

Back
Top